Macro fire descargar 20211/9/2024 ![]() This is only an example of how the simulate works. to move the THC up, only if you hit the T key will it move. Example if you use the Up for the up THC and simulate with the key of T only the keyboard T will operate that function. Ok with Mach 3 when you select simulate mode that takes full control of that function. Instead of adding an M14, and M15 you can just edit M3 and M5 to add in the following code which will then do what you want it to without having to use G92.1 to clear the temporary offset (G92).Įdit M3 Macro to amend / add the following code Move in Machine Coordinates, these NEVER change, until you next home the machine again and reset the machine co-ordinates again The fix (correct way to do what you are trying to do) is use G53. your M15 tries to clear this with G92.1īut if you stopped the cut part way through it would not run the G92.1 and your torch will crash when you next run Your macro works in "Work" co-ordinates G92 provides an offset to the Work-Coordinates. you do need to consider the difference between "Work" co-ordinates and "Machine" co-ordinates. That is fine, lots of guys do do that (such as in Linuxcnc for instance + with the Neuron THC). I presume you are using G28 to home the axis to the top / highest point on the Z-axis furtherest away from the table / material. ![]() You can use a macro to automate the process if you wish (difference between 6 and 2 three's. It sends the torch down to -50mm at a fast pace, then slows it up to -85 (it will always hit the material between -60 and -80mm) my Z axis homes in the up position at about 75mm from the table. This macro is called M14 on my machine so when a cut is required I use M14 (which includes M03 to fire the torch) It works really great, I am using the spindle delay feature for my pierce delay with an on screen DRO to adjust the pierce delay, I would like to also put the pierce and cut height on a screen DRO as well to easily adjust (instead of modifying my macro each time) is there anyone out there that might be able to help me with this? If you have any other suggestions as far as any possibly speed changes. ![]() I would like also do that in Mach3, I am currently using a floating head with a homemade macro. I was reading a post on here (can't find it now) about a floating head plasma that used on screen DROS to set the pierce and cut height. ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |